ステンレス鋼箔材の抵抗シーム溶接における溶接条件の最適化
Optimization of Welding Conditions for Resistance Seam Welding of Stainless Steel Foil Material
- 提供方法
- 他サイトにて提供・販売
- 入手方法の確認はこちら
- 文献番号
- 20254051
- 文献・情報種別
- 自動車技術会論文集
Vol.56 No.1
- 掲載ページ
- 159-164(Total 6 p)
- 発行年月
- 2025年 1月
- 出版社
- (公社)自動車技術会
- 言語
- 日本語
書誌事項
| カテゴリ | 論文 |
|---|---|
| カテゴリ（英） | Paper 翻訳 |
| 著者 | 1) 小山 紫温, 2) 金野 凌, 3) 西野 創一郎, 4) 吉川 誠也, 5) 野上 哲也, 6) 荒谷 玲那 |
| 著者（英） | 1) Shion Koyama, 2) Ryo Konno, 3) Souichiro Nishino, 4) Seiya Yoshikawa, 5) Tetsuya Nogami, 6) Reina Araya |
| 勤務先 | 1) 茨城大学大学院, 2) 茨城大学大学院, 3) 茨城大学大学院, 4) ART-HIKARI, 5) 野上技研, 6) 野上技研 |
| 抄録 | 本研究では，ステンレス鋼箔材の抵抗シーム溶接技術の確立（接合強度の安定的な確保と連続したナゲット形成）を目的とした．実験を行った全板厚（200，100，50，20µm）において，十分かつ安定した接合強度を得ることができた．箔材の抵抗シーム溶接技術で重要なパラメータは，電流値と電極先端Rである． |
| 抄録（英） | The purpose of this study is to establish resistance seam welding technology for stainless steel foil materials. To establish the technology, we investigated whether the joint strength was sufficient and stable (Target: 80% of base metal strength), and whether nuggets were formed in a continuous overlapping pattern. Sufficient and stable joint strength was achieved for all foil thicknesses tested (200 μm, 100 μm, 50 μm, 20 μm). The important parameters in resistance seam welding technology for foil materials are current value and curvature radius of electrode. For 200 μm and 100 μm thick foils, fracture pattern was base metal fracture. The fracture occurred at the softened zone near the welding zone. For 50 μm and 20 μm thick foils, fracture patterns were divided into base metal fracture and joint interface fracture. Differences in fracture patterns may cause variations in strength. As the thickness in the foil material decreases (50 μm, 20 μm), the nugget disappears and the continuity of the nugget in the welding zone is lost. Nuggets could not be formed even when the current value and curvature radius of electrode were changed. However, the target values for joint strength were also achieved for solid phase bonding. 翻訳 |
