Numerical and Experimental Analysis of Abnormal Combustion in a SI Gasoline Engine with a Re Entrant Piston Bowl and Swirl Flow
- Delivery
- Available on this site
- Format
- Price
- Non-members (tax incl.)：￥1,100 Members (tax incl.)：￥880
- Publication code
- 20229038
- Paper/Info type
- SETC
No.2022-32-0038
- Pages
- 1-11(Total 11 p)
- Date of publication
- Oct 2022
- Publisher
- JSAE
- Language
- English
- Event
- SETC2022
Detailed Information
| Author(E) | 1) Ayano Matsuoka, 2) Kentaro Shiraishi, 3) Shinji Kishi, 4) Jaeok Bae, 5) Makoto Kaneko, 6) Tatsuya Kuboyama, 7) Yasuo Moriyoshi |
|---|---|
| Affiliation(E) | 1) Kubota Corporation, 2) Kubota Corporation, 3) Kubota Corporation, 4) Chiba University, 5) Chiba University, 6) Chiba University, 7) Chiba University |
| Abstract(E) | Some SI (spark-ignition) engines fueled with gasoline for industrial machineries are designed based on the conventional diesel engine in consideration of the compatibility with installation. Such diesel engine-based SI engines secure a combustion chamber by a piston bowl instead of a pent-roof combustion chamber widely applied for SI engines for automobiles. In the development of SI engines, because knocking deteriorates the power output and the thermal efficiency, it is essential to clarify causes of knocking and predict knocking events. However, there has been little research on knocking in diesel engine-based SI engines. The purpose of this study is to elucidate knocking phenomena in a gasoline engine with a re-entrant piston bowl and swirl flow numerically and experimentally. In-cylinder visualization and pressure analysis of knock onset cycles have been experimentally performed. Locations of autoignition have been predicted by 3D-CFD analysis with detailed chemical reactions. The prediction accuracy of the location of autoignition has been examined by comparing with experimental results. Initial and boundary conditions for 3D-CFD are obtained by TPA (Three Pressure Analysis), which is a 1D engine cycle simulation using measured intake/exhaust and in-cylinder pressures as the input data. Locations and timing of autoignition have been observed through an endoscope attached to the cylinder head. The visualization area through the endscope is determined based on the location of autoignition predicted by 3D-CFD analysis. The in-cylinder pressure is also measured simultaneously, and the maximum amplitude of the pressure oscillations after applying a high-pass filter to the in-cylinder pressure is used as knock intensity (KI) to determine knock onset cycles. From results of the in-cylinder pressure measurements and analysis by TPA, the relationships between in-cylinder conditions and KI are analyzed. The comparison between visualized and calculated location of autoignition have been shown good agreement in the case that both the maximum and the low engine speed conditions. |
