ローラチェーンの疲労強度に及ぼす外プレートへのピン圧入の影響
Effect of Press Fitting Between Pin and Outer Plate Upon the Fatigue Strength of Roller Chain
- 提供方法
- 他サイトにて提供・販売
- 入手方法の確認はこちら
- 文献番号
- 20214422
- 文献・情報種別
- 自動車技術会論文集
Vol.52 No.4
- 掲載ページ
- 738-743(Total 6 p)
- 発行年月
- 2021年 7月
- 出版社
- (公社)自動車技術会
- 言語
- 日本語
書誌事項
カテゴリ | 研究論文 |
---|---|
カテゴリ(英) | ResearchPaper 翻訳 |
著者 | 1) 斉藤 亮一, 2) 野田 尚昭, 3) 佐野 義一, 4) 宋 健, 5) 南 健瑠, 6) 宮城 新, 7) 岡村 知明 |
著者(英) | 1) Ryoichi Saito, 2) Nao-Aki Noda, 3) Yoshikazu Sano, 4) Jian Song, 5) Takeru Minami, 6) Arata Miyagi, 7) Tomoaki Okamura |
勤務先 | 1) センクシア, 2) 九州工業大学, 3) 九州工業大学, 4) 九州工業大学, 5) 九州工業大学, 6) 九州工業大学, 7) 九州工業大学 |
抄録 | ピンとプレートの圧入率を変化させてローラーチェーンの疲労強度を評価した.疲労試験には,両端部を穴あけされたプレートに,ピンが圧入嵌合された試験片を用いた.また耐久線図による強度評価を行うため,FEM解析を行った.試験の結果,圧入率δ/D>0は,δ/D=0よりも,疲労限度が向上することがわかった. |
抄録(英) | In this paper, the fatigue strength of the roller chain is investigated by varying the press-fitting ratio between the pin and the plate. A single plate specimen with two pins press-fitted into two holes at the plate ends is used in the fatigue test. The FEM analysis is performed to obtain the stress amplitude and the average stress on the fatigue endurance limit diagram. The results show that the fatigue strength can be improved under suitable press-fitting ratios δ/D=2.5×10-3, 5.1×10-3, 9.5×10-3 compared to the fatigue strength under press-fitting ratio δ/D=0. 翻訳 |