ピッチ差付きナットの異なる呼び径における適切なピッチ差についての考察
Suitable Pitch Difference of the Nut to Realize Anti-Loosening for Different Bolt Nominal Diameters
- 提供方法
- 他サイトにて提供・販売
- 入手方法の確認はこちら
- 文献番号
- 20224177
- 文献・情報種別
- 自動車技術会論文集
Vol.53 No.2
- 掲載ページ
- 418-423(Total 6 p)
- 発行年月
- 2022年 3月
- 出版社
- (公社)自動車技術会
- 言語
- 日本語
書誌事項
カテゴリ | 研究論文 |
---|---|
カテゴリ(英) | ResearchPaper 翻訳 |
著者 | 1) 野田 尚昭, 2) 川野 凌, 3) 王 彪, 4) 佐野 義一, 5) 高瀬 康 |
著者(英) | 1) Nao-Aki Noda, 2) Ryo Kawano, 3) Biao Wang, 4) Yoshikazu Sano, 5) Yasushi Takase |
勤務先 | 1) 九州工業大学, 2) 九州工業大学, 3) 九州工業大学, 4) 九州工業大学, 5) 九州工業大学 |
抄録 | 本論文では,ピッチ差付ナットの異なるボルト呼び径に対する適切なピッチ差についての考察を行った.M12のユンカー式緩み試験で得られた適切なピッチ差からねじ山のオーバーラップ長さを求め,他の呼び径に適用した.得られた結果の妥当性をFEM解析でプリべリングトルクを求め検証した. |
抄録(英) | The pitch difference nut can be used in automobiles and other industries to improve anti-loosening and fatigue strength with low cost. In this paper, based on the suitable pitch difference α experimentally obtained previously for JIS M12 and M16, the suitable pitch difference is discussed for other bolt nominal diameters. Here, the overlap thread length is calculated from the suitable α obtained for M12. Then, the same value of is assumed to estimate the suitable α for other diameters. The validity of this theory is confirmed through calculating the prevailing torque for other diameter by applying FEM analysis. 翻訳 |